Front Door Latch Stuck In Open Position

Door lock doesn t latch properly when a door latch doesn t click into position it usually means the latch and the strike plate are out of alignment.

Front door latch stuck in open position.

Repairs range from making minor latch adjustments to repositioning the door. There can be a door latch stuck open or a door latch stuck closed but the reasons for each can vary quite a bit. Repairs for a stuck or broken door latch lubricating the door latch may allow it to open and close if rust is the culprit. Disclaimer this video was crea.

The solutions and severity of this issue will differ depending on what type of lock it is. Many of these can be fixed by simply disassembling and reassembling the door knob mechanism. With your door lock stuck in unlocked the position your home can be made vulnerable. Tighten the hinge screws and then try adjusting the strike plate by loosening its screws and shifting it slightly.

Either way your process starts by removing the doorknob from the door. The first step is to troubleshoot the issue and get a sense of what the symptoms are with the door latch stuck in its position. It may cause the latch to get stuck inside because it is slightly bent. Troubleshooting a stuck door latch try to open the door while it is shut.

The most pressing will be when your deadbolt door lock is stuck in the open position because your deadbolt provides the real security for a building. Once you have the door handle off you can now try to open the latch manually with either a large flathead screwdriver or pair of needle nose pliers. For the stuck latch shoot some oil silicone spray or wd 40 into the latch mechanism on the door. Try opening the latch with the door handle and see if it now works.

This is a short video to demonstrate how easy it is to remove a door handle view what s inside and repair the failed latch. A handful of things can cause a door latch to get stuck in the open position. You can see where the cylinder entered the dead latch mechanism and pulled the latch back. On the kwikset locks this looks like two little teeth that the cylinder pushes back.

Let it soak in then rub it into all the visible parts with a clean cloth.